Hey everyone, I've got a freestanding Mt Vernon pellet stove that has been giving me an Auger Jam error. I've taken the assembly apart and cleaned everything out, including cleaning the optical sensor. I put everything back together and the stove ran (including the auger motor) for about 10 minutes and the error popped up again. I purchased a new motor from a local dealer and the stove ran for about an hour last night. Tried to restart this morning and the error pops up again. Any ideas on this?
Quadrafire Mt Vernon AE - Auger Jam
- Thread starter jamesphoenix
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
Lake Girl
Moderator
Did you check the auger bearing? New gasket when reinstalling? Looks like there was a software update for vac switch problems and auger jam.
http://www.tallpinesfarm.com/assets/Quadra-Fire-Mt-Vernon-Troubleshooting-Manual.pdf page 12 for feed motor troubleshooting
http://www.tallpinesfarm.com/assets/Quadra-Fire-Mt-Vernon-Troubleshooting-Manual.pdf page 12 for feed motor troubleshooting
- Status
Similar threads
