wood stove barrel

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
  • Hope everyone has a wonderful and warm Thanksgiving!
  • Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Status
Not open for further replies.

Chrism

Feeling the Heat
Hearth Supporter
Oct 8, 2009
326
Eastern PA
Im converting a 55 gal drum over to a pool heater with 50 ft of copper tubing secured to the inside top of stove. Do I need to put a stove top thermometer and keep it at 500 to 600 degrees ? Or do i really even have to worry about it since its outside? There are air control vents on it btw. Thanks for input .
 
With any appliance that heats hot water, a big thing to worry about is a rupture of hot water hitting someone.

My co-worker grew up with a hot water coil in his parent's fireplace. One day it popped with the fire going and shot shot embers / steam all over the living room. He was "lucky" that they were home at the time and were able to quickly manage the situation, but still, all the furniture / carpet in the living room had to be replaced due to damage, yet fortunately, even though they were there, they themselves were not injured.

I can't give any recommendations to this setup other than creosote / chimney fires, if far enough away from any structure, are the least of your worries.

pen
 
A steam explosion outside can be as lethal as one inside. Be sure there are good temp/pressure reliefs at all critical points.
 
To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.
 
Have you done some calculations to determine how much copper tubing you need? It has been a while since I took thermodynamics. You will need to figure out if the water will move through the piping and not convert to steam and cause a large pressure difference. Basically, you have to make sure the hot steam pressure does not over come the resistance of the fluid flowing out of the pipe. There is a happy medium there and i would think less pipe would be safer. After all, even a short section of pipe will simply move water more quickly with less heat but at a greater flow rate. The overall heat exchange might be equal to that of a slower moving, long section of pipe at a higher exit temperature into the pool.
 
I think I would rather run solar water heater aka "poor man pool heater" I think it would be cheaper and safer to operate
 
Maybe the folks in the boiler room can give you more specific guidance?
 
Status
Not open for further replies.