I purchased an after market blower to put in my fireplace. The problem with this unit is that there isn't enough room at the bottom to slide the blower in. It is recessed into the floor. I'm guessing the whole thing has to be disassembled. I can't find any info anywhere on installing a blower on one of these. Suggestions anyone?
Superior SLDVT-35NM Blower Installation
- Thread starter Boozer385
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
- Status
https://www.manualslib.com/manual/954913/Superior-Merit-Sldvt-30nm.html?page=30#manual
You will have to disconnect the gas line. Then remove the logs & the burner subfloor.
Once you are that far you should be able to see the zip screws that hold the burner pan in place.
Once you remove them the burner should lift right out.
Install your blower & reverse your steps.
You will have to disconnect the gas line. Then remove the logs & the burner subfloor.
Once you are that far you should be able to see the zip screws that hold the burner pan in place.
Once you remove them the burner should lift right out.
Install your blower & reverse your steps.
- Status
Similar threads
