So I bought an older Quadrafire Contour pellet stove secondhand. I think the stove is from 2001 (at least that seems to be the date on the control board.)
I had it working for a few days but now the auger does not feed pellets anymore. When I plug it in the exhaust blower comes on and when I turn the thermostat up the call for heat light turns red. I know the igniter works because I can drop some pellets into the fire pot and they catch fire but the fire obviously does not stay because no new pellets are being fed. On the control board I see a blinking yellow (possibly green) light and I am not sure what this means. This is the black opaque control board, not the transparent ones they have now.
I have tried jumping all of the snap disks, checked if snap disk 3 needed to be reset, jumped the vacuum switch, removed the auger to check for jams, and checked for loose wires. None of those seemed to help.
Any help would be appreciated.
I had it working for a few days but now the auger does not feed pellets anymore. When I plug it in the exhaust blower comes on and when I turn the thermostat up the call for heat light turns red. I know the igniter works because I can drop some pellets into the fire pot and they catch fire but the fire obviously does not stay because no new pellets are being fed. On the control board I see a blinking yellow (possibly green) light and I am not sure what this means. This is the black opaque control board, not the transparent ones they have now.
I have tried jumping all of the snap disks, checked if snap disk 3 needed to be reset, jumped the vacuum switch, removed the auger to check for jams, and checked for loose wires. None of those seemed to help.
Any help would be appreciated.
Last edited: